Battery charger for Streamlight Strion battery
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This charger fits Streamlight Strion battery pack part 74175.Required additional components:Stainless Steel Self-…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 117
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Share Alike
This charger fits Streamlight Strion battery pack part 74175. Required additional components:
Stainless Steel Self-tapping screws M2.5x10mm or 8mm: https://www.amazon.com/dp/B00YBMROKC Pogo pins: https://www.amazon.com/dp/B07FPKKK9W USB Type-C TP4056 battery charger: https://www.amazon.com/dp/B07PZ6V937 Wire USB Type-A to Type-C cable, or modify the TP4056 board with resistors
To assemble, carefully solder wires to the solder posts on the pogo pins, being sure to not get past the flange or wet all the way around the post. File the solder down if necessary to fit in the grooves.
B+ connects to the center pin, and B- connects to the side pin.
The pogo pins should snap into the correct depth, but you might need a tiny amount of glue to hold them in place before attaching the lid.
Please note these TP4056 boards have a small flaw where USB type C ports won't power up the board. This can be fixed by connecting 5.1kΩ resistors from each of the 2 center pins of the port and pulled down to ground.
You can see the LEDs of the charger through the vent holes; the light will be red while charging then turn blue when charging is complete.
Category: Gadgets