Milwuakee Oscilating Multi-Tool Plunge 2526-20
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Milwuakee Oscilating Multi-Tool Plunge to cut out percise openings in cabintry. Designed for the 2526-20 M12 tool
- Ocena
- 0 / 5
- Polubienia
- 34
- Pobrania
- 56
- Wydruki
- 0
- Wyświetlenia
- 1031
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Hey Guys
I created this model and I'm sharing it with the comunity so that all can have this Multi tool plunge for the Milwuakee 2526-20
I'm open to any feedback or any critisim any one has… I will be updting this model if it needs any fine tunning
IMPORTANT: When you get your rods from ALI Express some of them might be slightly bigger or smaller in diameter… I have release a few version of the base with tighter tolerances just in case… I have one with 10.2mm and another one with 10.25mm
I provided the step file for anyone that would like to modify this design.
Here is what you need to make this work for you
2 - M4 x 30 mm screws (to clamp the Milwuakee down to the base)
1 - M4 x 10 mm (screw for the stop)
2 - M4 x 8 x 6 inserts
2 - M4 x 10 x 6 inserts (used for the hole openings to secure the base)
1 - 10 mm diamter x 300mm Rod (metal or carbon fiber cut to about 120mm - 150mm)
2 - Springs 1.0mm x 13mm x 70mm
1 - roll of rubber gasket 70 mm - 80mm wide (this is used to stick to the bottom of the base to prevent the plunge moving around)
All of this can be bought at ali express for dirt cheap… Enjoy and I'm open for any suggestions
VERSION 2 Base and Allen Key holder
If you are using the same M4 screws as I am then you need to have an allen key. In this version I updated the base to include a nice allen key holder