1 / 8
Filament Guide Add-On Angle Adapter Low Friction for OPE
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
OPE Filament Guide Angle Adapter 15° to reduce friction, suitable for Original Prusa Enclosure
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 69
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution
OPE Filament Guide Angle Adapter 15° to reduce friction, suitable for Original Prusa Enclosure
Changes to the Filament Guide position
- 15 degree angle, slanted towards the filament spool.
- 10mm to the right
Caution, reduces accessibility to the filament guide, when inserting filament!
Additional Parts
Additional parts needed (included as spare parts with the Prusa Enclosure):
- 2x M3n nut
- 2x M3x8 screw
Installation
Insert two M3n nuts into the adapter. Tip: Use the 2.5 mm Allen key with M3x12 screw to completely pull the nuts inside.
Now fasten the Filament Guide onto the adapter using its two M3x12 screws. Put the part in the upper corner of your enclosure and fasten it with two M3x8 screws from the outside.
DONE!