V2 - Presonus EarMix 16M & Sennheiser SR IEM G4 Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Keeps an EarMix 16M on top of a SR-IEM G4 transmitter unit!
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 83
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Share Alike
Keeps an EarMix 16M on top of a SR-IEM G4 transmitter unit! This time without needing magnets or any additional hardware.
This design aims for a closer slim-fit around the edges of the EarMix, adding guards around the front, rear, and sides. The total parts to print are:
4 of the SR-IEM pegs
Left EarMix mount
Right EarMix mount
The pegs attach to the mount by way of an interference fit. I designed the model with a 0.2mm tolerance, and that seems to work sufficiently. I considered adding a draft to the pegs, but that left it too lose for the angles I tried.
Why I moved away from the V1 design:
I moved away from the design that uses magnets since the original idea was to make it easy to swap EarMix controllers out if necessary (since keeping one controller for a specific band member/spot keeps their mix consistent for them). The magnet system looked like it would do that, but that was only if feet were made for each controller and left attached. That would mean buying screws and magnets for each of them, and attaching the magnets.
Along with this, even with the little alignment brackets to help to hold it in place, V1 wasn't as secure as I would've hoped. The EarMix was still able to move around from side to side and front to back more than I would've liked.
07/15/2026 Update
Still going strong! What I've learned now is that the interference fit is a bit too finicky still, when assembling I commonly have issues with the side rails not attaching like they're supposed to. I don't want to make it a single printed unit, but I need a better way to peg the earmix mount in place.
Also, the little wings on the top that hold the EarMix in place are a bit too thin, they've broken off a couple times if the EarMix is accidentally bumped aggressively.
Will fix eventually lol