1 / 7
Filament Holder Low Friction Add-On for Original Prusa Enclosure — zdjęcie 1
1 / 7

Filament Holder Low Friction Add-On for Original Prusa Enclosure

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Enclosure Add-On for 1 kg spool with 49 to 79 mm inner diameter, two sizes with adapter.

Ocena
0 / 5
Polubienia
4
Pobrania
25
Wydruki
1
Wyświetlenia
154
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Filament holder to reduce spool friction, suitable for Original Prusa Enclosure

 

Additional Parts

  • 1x M8 threaded rod / Gewindestange (110 - 120 mm)

  • 1x M8 nut / Mutter

  • (1x M8 washer / Unterlegscheibe)

  • 4x 608 bearing

  • Glue / Kleber

 

Choose the right version for //Part: Mount Spool Holder// depending on installed //Spool-Holder-R// in your Original Prusa Enclosure

→ Version A (newer)

→ Version B (older)

 

 

Print instruction

Recommended filament: 

  • PETG or more heat resistant filament (ABS, ASA,…)

  • TPU for Part: Flex Washer for Thumb Screw M8

Use PAUSE PRINT in slicer for Part: Thumb Screw M8 plus Washer for Spool Holder mid-print to place the M8 nut (and M8 washer) into the part.

 

Installation

  • Screw the threaded rod inside Part: Mount Spool Holder, it should screw all the way in with moderate force. 

    • Tip: If you need more leverage use the allen key hole on the side. Don't overtighten, we will glue it together in the next step.

  • Now you can put some glue on one end of the threaded rod and secure the Part: Mount Spool Holder onto it.

  • Take Part: Thumb Screw M8 plus Washer for Spool Holder and Part: Flex Washer for Thumb Screw M8 and twist it until it fits together.

  • …

 

DONE!

||||||||||||||||||||||||||||||||||||||||||||

Additional Add-On's for Original Prusa Enclosure (OPE)

 

Filament Guide Adapter: https://www.printables.com/model/1330316-filament-guide-add-on-angle-adapter-low-friction-f

Door Seal: https://www.printables.com/model/552897-original-prusa-enclosure-ope-door-seal-heat-retent

Heater Addon (Stage 1) [WIP]: https://www.printables.com/model/966315-original-prusa-enclosure-heater-addon-stage-1-wip

 

Tagi