Transit Tracker Frame
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Frame for the Transit Tracker, a DIY public transit arrivals board
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 755
- Wydruki
- 2
- Wyświetlenia
- 1816
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Transit Tracker is an open source DIY public transit arrivals board by Eastside Urbanism. It's like the boards you see at a train station, but miniaturized for home usage. Never be late for your bus, train, ferry, or gondola again!
This is the frame/enclosure which houses the display panels and electronics. It's designed to be printed twice - once for each half.
Instructions
There are two different versions of the frame in the downloads. You should choose one depending on how well-tuned your printer is:
Loose Tolerances: Provides more leeway to fit the LED matrix panels inside the frame, but may result in unsightly gaps around the edge. Use this one if you are unsure.
Tight Tolerances: Panel dimensions are more exact and results in a better fit and finish, but requires a properly-tuned printer.
Full build instructions, including slicer recommendations, can be found in the build guide.
Technical Details
While this frame was designed for the Transit Tracker, it's really just an enclosure for two Waveshare RGB-Matrix-P2.5-64x32 panels with an Adafruit Matrix Portal S3, so you could easily repurpose it for any other project which uses this kind of display. Please post a make if you use this frame for your project; I would love to see what you come up with!