1 / 4
Gateway GWTN141-10 Notebook Bottom Drive Cover
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a replacement for the bottom drive cover. It's tight enough to not need the screws if you've lost yours.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 48
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Public Domain
Will this fit your laptop with a different model number? Maybe, if the opening is ~82mm X 30mm.
I printed it with PLA because it's what I had that isn't black:
- 0.20mm nozzle
- 0.2mm layer height
- 15% infill (Gyroid for no specific reason)
- No brim
- No supports
- 210C / 60C
- Scarf Joints (left over from a previous project, but I like it)
- Printed face down (see example image)
The recessed screw hole will get a little sloppy from being printing inverted. Supports made it worse.
The hinge side tabs needed some filing to get that corner to be a sharp 90 degrees for tighter operation.
Laptop: https://www.gatewayusa.com/products/14-1-fhd-ultra-slim-notebook-1