1 / 4
Beer Can Lid/Soda Can Lid/Bug Cover (no supports needed)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of EcoDad's design. This will not spill fluid on sides when drinking. See picture for difference.
- Ocena
- 4,962 / 5
- Polubienia
- 289
- Pobrania
- 2842
- Wydruki
- 25
- Wyświetlenia
- 6721
- Oceny
- 26
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 25) (Komentarze: 27)Remiksy (0)Kolekcje (401)Powiązane
Adjusted angle so it will not spill fluid on sides.
I use 5mm drill bit softly inside hole after printing to clear up any mess.
And after some fast turning back and forth it will slide really well.
When it slides really well its easy to dismantle and clean it in the spring.
I am not going to post any with names because I handle that in Bambu slicer.
I printed with 0.6 nozzle
No Narrow, yet.
