Ryobi Power Bank 18V and 40V
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ryobi power bank for use with both the 18 volt and 40 volt batteries.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 137
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model uses the popular 30 mm diameter USB car charging socket to provide USB power from both Ryobi 18 volt and 40 volt batteries. The charging socket I used was the only one I found that had the input voltage range for both the 18 and 40 volt batteries. I include the link below. It has a voltage display and on/off power button. It provides both PD 30W USB C and QC 36W USB type A. It comes with a fuse holder and enough wire to complete this project.
The model has two parts. A top and a base. The parts screw together with four #8x1/2inch flathead screws. The holes can be drilled out for different screw sizes. My models are sliced at 100% fill. Only the base requires supports. The supports are easy to pop out with a small screw driver.
The electrical contacts are made from galvanize vent duct pipe or a steel food can. I cut strips and bent it to match the what is in the photo. It was easy to solder. For the wiring, I used the wire supplied with the charger socket. Wires are solders to the plates and then soldered together and shrink wrapped.
The photos show a previous version. The final models includes some minor update to improve fit..
https://www.amazon.com/dp/B0CWP7MNYV?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1&th=1