Gardening Tool - Mini Trowel and Fork for Seedlings
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Just for popping seedlings out of trays with soft compost. Too fragile for digging weeds out of clay!
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 71
- Wydruki
- 0
- Wyświetlenia
- 216
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Styled on the cheap tools you can get from supermarkets, but this costs about 13p to print and if you break it you just print another :o)
Works fine for separating out young seedlings for potting on or planting out in the garden.
I used PLA+ so anything stronger would be even better. 0.4mm nozzle, 0.2mm layers unless you want to halve the jaggies in which case use 0.1mm. You WILL need to support the trowel end, it should be orientated so that the scoops of both ends are facing upwards, which means the tip of the bottom of the trowel is curving upwards off the printbed. I used “support touching buildplate", 50deg support overhang angle, 25% support density to get enough lines, and support pattern = grid. This left the bottom pretty rough after separation of support but it's a crude tool anyway, and if you want it smoother then just sand/file off the roughness.
The corners are a bit sharp thanks to some grief in Fusion360 in getting all the edges to fillet - I should really chamfer the bottom and may get around to that sometime especially if someone asks for it!
I was tempted to design a matching dibber like you get in the 2-piece kits, but frankly all you need is a stick, hehehehehe!
Please Like this model if you find it useful.
If you REALLY like it, https://www.buymeacoffee.com/gigabeast :o)