cable pull with 608 bearing for roof box, bike, garage //Seilzug mit 608-er Kugellager für Dachbox, Fahhrad und Garage
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Didnt want to spend too much money on some shitty set from amazon - so I designed myself.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 171
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution
Aim was to keep it lightweigt and still have some "extras"
My goal was to lift the roofbox with onyl one paracord but on 4 lifting points. So the paracord needed to go in a circle.
I dont rely on the rope to hold the weight forever. So the lifting part can be secured on the ceiling part.
As bearings I used the 608 bearing which you can easily get everywhere for a small amount of money. I use them a lot for 3D dryboxes and stuff.
It is designed to be used with a 4mm rope aka paracord.
There are basically two installing options on the ceiling.
I personally prefer M6 metric screws with metric anchors for concrete - please look out for M6 in the filename
But I made a version for standard countersunk screws with normal plastic dowel - please look out for spax in the filename
To help with the hole drilling there is a drilling_helper
With the Pulley there are three major versions.
For all of them: the 608 bearing with the roller is secured with an M8 bolt and nut. There is a litte 1mm distance block. So you can fasten it quite tightly and there should not be any clearance between the part - but the bearing will have clearance to spin freely.
A:
one simple one which only holds two rollers:
608_pulley
in version _M6 or _spax
B+C:
Then we have the ones which lead the rope around the corner. one for the right side and on for the left side.
There a third roller guides the paracord around the corner.
Also again for ceiling mount with M6 or spax
For the third roller there are two installing options: Hex Nut/Screw or M8 Screw if you carve an M8 thread.
With the M8 hex screw inserted from the bottom the length of the screw doesnt matter.
608_pulley_M6
...M8Nut
...M8Nut-L
...M8thread
...M8thread-L
and also for the countersunk screw we have:
608_pulley_spax
...M8Nut
...M8Nut-L
...M8thread
...M8thread-L
for the lifting
only missing thing is the moving part to lift your gear.
Its the 608_pulley_puller.
It has an M6 hole for mounting whatever comes to your mind whoever you want. I will just use paracord.
on the other side it also has a M6 hole. When it is at the top this part and the ceiling part can be secured with an M6 screw.
And of course there is the pulley for the bearing.
Just press the bearing into it - maybe with a hammer or better with a vice.
Printing:
Print orientation is upright standing for best strenght. All corners are rounded, but one. So this one should be an your build plate.
Overall printing should be very easy - no supports needed.
For best stability I advise ABS or ASA.
If the weight is not too much, PETG should also be ok-ish.
finally:
please leave me a like or a comment!