PCIe Riser Cable Mount for Jonsbo N4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
PCIe Riser Cable Mount for Jonsbo N4 case
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 710
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Public Domain
I’m using a mini-ITX motherboard inside a Jonsbo N4 case. The board has a single PCIe slot with bifurcation support, and I needed to connect three devices: a SAS controller, a 5GbE NIC, and an NVMe SSD.
Hardware I used:
- Mustpoint Dual NVMe PCIe Adapter: https://www.amazon.com/dp/B0DDP986J3
- LINKUP riser cable: https://www.amazon.com/dp/B07CS38177
This custom mount allows you to secure the riser cable using the unused microATX standoff holes and the standoffs included with the Jonsbo N4 case.
The source OpenSCAD model is also provided.
Required mounting hardware:
- 2 x M3x8 bolts
- 2 x M3 Nuts
- (Optional) 2 x small washers (I used #6 washers)
Recommended filament: PETG or ABS for better heat resistance (I used PETG).
Note: I had to trim about 3 mm off one end of the riser cable’s PCIe slot bracket, as it was slightly too long to fit properly.