Filament Spool Stand Base for 25 mm Pipes/Dowels
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For putting away your filament rolls neatly and nicely
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 99
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
5 July 2025: Added a version with a bump in the middle – so the filament rolls don't slide off the side
Made some “legs” for the 25 mm pipes I had, so I can turn them into a filament stand!
Pipes have to be inserted into slots from the side, not just laid on top (on purpose, so the pipes don't fall out if you bump into them).
Print two “Left or Right” STLs for the pipe ends. If you plan to use wooden dowels or extra long pipes, I recommend also printing the centre bit, to avoid sagging.
I recommend printing with at least 3 walls and 15% infill minimum.
Please comment, rate the model and kindly post your makes for everyone to see!
Advice and requests are welcome!