Sketch board / Drawing Board alternative for Samsung Galaxy Tab S8/S9 Ultra (14.6") with Adjustable Legs

Introduction

Hey, following on from my last model https://www.printables.com/model/1011810-sketch-board-drawing-board-alternative-for-samsung/files and being inspired by Jimmy Lan Studio, please check him out, (his iPad stand video https://www.youtube.com/watch?v=cel99VK0jfY&t=482s)  I decided to make a newer version my sketch board, with adjustable legs for multiple angles, it’s not perfect as the brass ball latch causes minor cosmetic damage to the bottom latch gear as it Pivots, however it is still very functional!

Printer Settings
Layer height: 0.2mm
Infill: 15%
Supports: Yes, should only be for the BOTTOM_LATCH
Wall loops: 2
Detect thin wills: on (especially for the BOTTOM_LATCH AND TOP_LATCH_HOLDER)
Print time: Approximately 20 -25 hours 
Filament: Approx a full 1kg spool should suffice, I used ELEGOO Matte PLA Filament Ruby Red and ELEGOO PLA+ Clear, but PLA should be sturdy enough to do the job 
Printer: Bambu Lab P1S

Hardware Required
•    8x M3 8–10 mm screws
•    6–10x 5 mm Dia Brass Ball Catch Latch Catchers
•    8x 5 mm x 20 mm Dowel Pins (optional)
•    1x MagSafe Ring Wall Mount (optional)
•    1x MagSafe Ring Sticker (optional)
•    1x Slim Tablet Case for S9/S8 Ultra (optional)
•    1x Erasable Marker or Pencil (for alignment)
•    Clear Gorilla Double-Sided Tape (for mounting MagSafe holder)
•    Super Glue (optional)

Hardware Links used by me:

• https://www.amazon.co.uk/dp/B07G7HC5TP (Bras Ball Catch)
• https://www.amazon.co.uk/dp/B0D8TGLWQ1 (Screws)
• https://www.amazon.co.uk/dp/B09ST5BL2S (Slim Tablet Case)
• https://www.amazon.co.uk/dp/B07MP9X6R3 (5 mm x 20 mm Dowel Pins)
• https://www.amazon.co.uk/dp/B0B7JBF8BG (Magsafe Wall Mount)
• https://www.amazon.co.uk/dp/B0DXKWHDD7 (MagSafe Ring Sticker)

Assembly Information

The full model – if you’re lucky to have a print bed big enough, I’ve attached the whole model. If not, I have split the model into four pieces, one with 5mmx20mm dowel holes and one with none

LL (Lower Left)

LR (Lower Right)

UL (Upper Left)

UR (Upper Right)

(see in pictures)

Please see the attached Assembly Guide PDF for installing the Adjustable legs in the Other Files section

Extra Notes

I would recommend using a stronger Magsafe than the one I have, as the magnet is not strong enough to fully secure it from falling off with enough force , but is strong enough at steeper angles to keep it secure while using it, I've also included a .step file for Magsafe Holder with no ring, so you can add your own ring mount if needed. 

Please take in mind as well, this was designed to fit the Samsung tablet with a case as well, so it may not be as snug when using the tablet naked, I will be releasing a TPU insert soon to help counter this issue.

Please also take a look at the Slicer files to see the proper orientation and support needed.

Coming Soon

• TPU inserts for a more snug fit, if you decide to use it without a case
• improved BOTTOM_LATCH design that stops minor cosmetic damage