1 / 9
Ride-on Power-Wheels trailer and working hitch V1 — zdjęcie 1
1 / 9

Ride-on Power-Wheels trailer and working hitch V1

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

An easy 90% printable trailer for kids ride-on vehicles.

Ocena
0 / 5
Polubienia
12
Pobrania
23
Wydruki
0
Wyświetlenia
341
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Outdoor Toys
Licencja
Creative Commons — Attribution — Noncommercial

Designed this for my son's 12v ride-on toy. He gets to help with yard work in a fun way, and gets to learn a little about backing up a trailer. The whole assembly is lightweight and pulls with no trouble in grass. It's all been designed to be strong and printable with no support, except the rails, where using supports saves a lot of material.

Bill of Materials

The only non-printed part is a small 18"X24"(As shown) piece of 1/8" wood, acrylic, coroplast, tec, and hardware. 

I recommend ASA if you lease this outdoors. I used petg because i know my son will break it before the sun does.


Wheel Mounts:

  • 8X M3X12 button head bolts
  • 8X M3 heat set inserts
  • 8X M3 washers

Trailer Tongue

  • 5X M3X15mm button head bolts
  • 5X M3 heat set inserts

Trailer Hitch

  • 6X M3x12 flat head bolts
  • 6X M3 fender washers
  • 6X M3 nuts 

Side rail(As shown)

  • 24X M3X20 flat head bolts
  • 24X M3 heat set inserts

Rails

The side rails interlock for strength. Slip the parts on the side of the bed, then mark the bed and remove the rails to drill through the bed. Alternatively, you can use the rails as a guide to drill the holes. Finally, reinstall the rails and clip the ends together. Install heatset inserts on the bottom side of the rails.

Bolt in place using M3 flat head bolts.

Print rails with support, with the side of the rail down for best strength and appearance. 

General Printing Notes

All parts are sized to print on small(255x255mm) build plates like neptune 4, X1C, Centauri, etc. you may want to scale up for your ride height if you have the printer space. If you do scale up, you should swap m3 hardware for a bigger size. M4 hardware will also work, but the heatset holes are sized for m3 as uploaded.

Total print time on prusa XL is 2 days. 1.4Kg of material at .2LH 15% triangle infill with snug supports and brim on rails only

Assembly Notes

Mark all hole locations first, using the parts for a template, then install heatset inserts. It will be a lot easier this way.

You can use and 1/8” thick material for the bed, but be aware of weather resistance. If you use hardboard like i did, it will basically fall apart in the rain. I just had leftover pieces from another project.


Tighten the hub nuts, then back off to align the closest locking slot. Insert the nut lock through the face of the hub nut to prevent the wheels from backing out or tight against the wheel.

To attach the trailer hitch, locate the hitch where you want it, then clamp it in place and drill 6X M3 clearance holes. Bolt in place using fender washers and 3mm bolts.

Tagi