AeroGarden Wire Rack Stand - Top Lock Version

These are some 3d printed stands that are designed to adapt AeroGarden Harvest gardens to Style Selections Steel Utility shelving units. This allows to garden to sit level on the wire shelving unit and be resistant to being bumped off the shelf. The “Top Lock” design is the version 2 design that is intended to make it easier relocate the garden on the wire shelf, but it removed the feature that locks the stands around the shelf itself. 

I like the “Top Lock” design a bit more than the older “Bottom Lock”, as the older design was much more of a pain to install and uninstall. Biggest disadvantage to the “Top Lock” deign, is the AeroGarden noticeably sit above the shelve.

Some notes: 

• These have only been tested with Style Select 4-tier Shelving units, but the design does have slack that might allow it to work with other units. 
• Currently only the following AeroGarden Harvests have stands available (more to come soon-ish):
  • AeroGarden Harvest Elite Slim
  • AeroGarden Harvest Standard
• If you used an AeroVoir, these stands will lower the water level in the garden by 13 mm. I am planning to do a “top lock” stand for the AeroVoir at some point as well. 

Design Project: Green Seed

====================================================================

Printed Parts needed:

2x AeroGarden Harvest [type of AeroGarden] Wire Shelf Stand - Top Lock

====================================================================

Hardware Needed for Top:

2x 150x10x10 MakerBeam Aluminum extrusions https://www.amazon.com/MakerBeam-150x10x10mm-beam-black-anodised/dp/B00G2DNT4I/  

4x M3x10 Socket Head Cap Screws https://www.amazon.com/BNUOK-120pcs-Stainless-Threads-Spanner/dp/B0DJQHJ8Y1?th=1