Raspberry Pi Model B (v1) Rack Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
You read that correctly... this is for the FIRST generation Raspberry Pi!
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 219
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Got a first generation Raspberry Pi Model B and rack mount it? Here you go!
- This model is for left rack mounting. You can't mirror it in your slicer because the mounting holes are not symmetrical.
- Printing is straight forward- the only area where supports are needed are the holes for the rack mount bolts.
- Use M3 bolts to screw the Raspberry Pi to the mount. Any short length should be fine. The bolts may need some oomph to bite into the material.
- I would recommend printing in PETG, but PLA should be fine.
Development
I'm a terrible 3D modeler, but I can slice things up easily enough in TinkerCAD. This one took some work!
The part where I needed to get the holes lined up juuuust right was the hard part. In the end, I went through 15 iterations to get those lined up correctly.
Iteration can take a long while, but there are many times when your slicer's features can be in your favor. To save on used filament, I used the cut tool in my slicer to print a 1mm sliver of the mount to test. On my Mk4S, the iterative print would only take about 30 min before finishing, so that was a huge time saver.
In the end, I got a product that works perfectly, and my first generation Raspberry Pi is mounted underneath a Raspberry Pi 4.
I think it came out well. :)