1 / 3
Foxeer M10Q-120 GPS Mount for BetaFPV Pavo20 Pro — zdjęcie 1
1 / 3

Foxeer M10Q-120 GPS Mount for BetaFPV Pavo20 Pro

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a custom 3D printed GPS mount designed specifically for the Foxeer M10Q-120 module on the BetaFPV Pavo20 Pro fra

Ocena
0 / 5
Polubienia
6
Pobrania
120
Wydruki
0
Wyświetlenia
690
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Public Domain

This is a lightweight 3D printed GPS mount designed specifically for the Foxeer M10Q-120, an ultra-light GPS module, on the BetaFPV Pavo20 Pro frame.
The mount provides a secure and clean installation while keeping the total weight minimal — ideal for micro drones where every gram counts.

Installation Instructions:

Remove the screws from the rear frame section of your Pavo20 Pro.

Align the holes on the printed mount with the screw holes on the frame.

Reinsert and tighten the screws through the mount to secure it in place.

Printing Information:

Material: TPU (flexible filament)

Infill: 100% (for structural integrity)

Support: Required

Layer height: Any (not critical)

Notes:

Designed for M2 screws (same as stock frame).

Optimized for GPS visibility and flight durability.

Perfect for builds that prioritize low weight and compactness.

Tagi