Vertical Stackable Planter

This vertical/stackable planter system is designed to be free-standing on a floor or table or can be mounted on a wall or post with the optional wall mount.  Four-sided, three-sided (against wall) or two-sided (corner) configurations are supported. 

The design allows for individual printing of each planter container to support large scale planter assemblies. There is no specific limit to how many tiers can be added aside from physical stability (or overall weight when wall mounted). 

By default, each tier is 100mm tall and with a combined 3 tier height/width of 300mm x 300mm. I printed a set at 175% scale with a combined 3 tier height and width of roughly 0.5 x 0.5 meters and it worked well for me for kale and peppers.

If growing vegetables or herbs, consider brushing on a food safe epoxy or similar coating on the inside of the containers and trays. I used Craft Resin Food Safe Epoxy.

By default, the wall/post mount is designed to use #10 or #12 screws (5-5.5mm). I recommend using fender washers when wall or post mounting. 

The clamp knob and nut are optional and connect each tier together to allow for easier transport of the assembled planter. 

For 2 and 3 sided configurations, the optional left and right gap supports provide extra support to the upper tiers (if needed), water drip flow redirect, as well as hide the dovetail block spine. 

Not expected by any means, but if you find this useful and you would like to buy me a coffee, you can donate at: https://www.paypal.com/paypalme/darwinsden.