1 / 6
Wall Mount Charger For Philips Norelco OneBlade
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for the Philips Norelco OneBlade that mounts to the wall. Easy charging by inserting trimmer into the holder.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 36
- Wydruki
- 1
- Wyświetlenia
- 205
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution
This holder/charger is designed to be used with the Philips Norelco OneBlade. The end of the charger that comes with the trimmer is secured in the holder so that when you insert the trimmer into the holder, it connects to the end of the charger as well. This is a two piece design that should be printed without any supports.
Assembly:
- Fasten the mount to the bathroom wall using #6 drywall screws. If you want to use other countersunk screws, just make sure that the face of the screw does not stick out and is flush with the face of the mount.
- Insert the connecter end of charger into the cutout of the base and fully press into the cutout. Make sure that the notch at the end of the charger is facing the front (curved side) of the base as shown in the picture so that the trimmer will be facing forwards when it is inserted into the base.
- Once the connector is fully inserted and in place, slide the base onto the mount. It should be a tight fit so that the base will not slide off of the mount whenever removing the trimmer.