Phillips 5000 series charging stand (MG5920/15)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A charging stand for your Phillips shaver, has routing for cable to fit snugly.
- Ocena
- 4 / 5
- Polubienia
- 8
- Pobrania
- 55
- Wydruki
- 1
- Wyświetlenia
- 242
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution
I have a Phillips shaver and wanted to have a spot to plug it in easily, so I could charge it when I needed to. I made this in Blender before I knew how to use CAD modelling software, but I think I did a pretty good job at getting the tolerances correct :)
The overall shape is pretty simple, I added noise to the outside so that it would create a nice rough outer layer. There's space on the inside to route your charging cable and then you're able to push it into the smaller recess so that it's snug and held in place for your shaver when you push it in and pull it out. I added indents underneath so that I could add double sided tape, as to secure it to the surface it's on but I never ended up using it. I printed this model on my Ender 3 S1 without any supports so any newer printers should manage just fine.
I tried to do some product shots with what I had on hand.