Leg extension for pittyesputty laptop stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Extension feel to raise the accepted center of gravity without tipping over.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 27
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
When printing this model, use the exact same settings and filament as you did for the original stand. Deviating from these settings may cause the model to deform differently than the original.
After printing the original vertical stand, I found it didn't provide enough stability for my laptop to be moved or used without concern. My laptop likely has a higher center of gravity than what the original designer anticipated. To address this, I created this model to extend the stand's legs, preventing it from tipping backward, even when the screen is fully open at 180°.
A Note on Powering On
You'll still need to hold the laptop in place to power it on. The power button has more resistance than the other buttons, and I didn't find it worthwhile to extend the stand further just for this.
Achieving a Perfect Fit
If you have well-calibrated Pressure Advance, this model should fit perfectly with the original stand. Mine, unfortunately, isn't perfectly calibrated, so I had to break the square in the middle to make it work. It still holds well with just friction, but you might consider using glue if you encounter the same issue.
Tested on Lenovo Legion 5 15ACH6H
I used an LLM to proofread and reformulate the text.