Vuse Holder for Ram Lower Mounting System
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The addition of this print to the Ram Lower Mounting System creates a secure charging dock for your Vuse Alto.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 165
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
When using the RAM Truck Lower Console Mounting System (Found below) you can now have a secure spot to charge and store your Vuse Alto. It’s designed with an angle cut at the top and meant to swivel toward the right when placing or removing your Vuse. This was done in order for it to fit properly as it can’t be moved any lower on the mounting plate. I used one of the holes in that mounting system that was already readily available to secure it. This print can also be used to add a Vuse holder to any vehicle.
https://www.printables.com/model/1151048-ram-truck-lower-console-mounting-system/comments
Assembly is easy;
- Insert your charger into the bottom of the holder
- run the cord through the slot on the bottom
- Click in the bottom piece making sure the slot for the cord on both pieces lines up
- This is where further assembly is optional
- If you are mounting the holder without using the RAM Console Mounting System you can either use a screw or 3M tape. With 3M tape you can simply slide in the insert and mount the holder wherever. If you will be mounting with a screw you should install it with the screw before sliding in the insert.
- If you are adding this to the RAM Truck Lower Console Mounting System then the simplest method is to slide in the insert piece and then add an M3 or M4 heatset insert into the back side. You can then screw the holder into place from the back side of your mounting plate.