HI-flow Extruder-Head For ANYCUBIC i3 MEGA

Light weight & High Cooling air flow extruder head For ANYCUBIC i3MEGA .

==ATTENSION==

Print cooling fan air flow is too strong in 100% fan speed.

You have to change cooling settings after install this Mod.

(ex:regular fan speed:20%,max:50%)

• CONCEPT

  • Best Extruder-Head with original cooling fan.

• TECHNICAL POINT

  • 15deg angled Heat-sink cooling fan. Fan and heat-sink center are allined.
  • Smooth heat-sink cooling duct.
  • 45deg angled print cooling fan and smooth print cooling duct.
  • no additional parts. Fans and bolt, nuts, you can reuse from original.

• RESULT

  • +High air flow in Heat-Sink & Print Cooler
  • +Better Overhang. High flow cooling duct. (80deg overhang are enable to print at 0.1mm layer hight)
  • +Reduced Weight 40grams .Print accuracy will become better.
  • +Offset extruder 5mm to Y-Rod . Print accuracy will become better.
  • -Offset extruder 5mm to Y-Rod. Print area is become small in Y direction 5mm.

• PRINT SETTING RECOMMEND

  • Retraction length default-->3.5mm
  • Please tune Nozzle heater PID after installing this MOD.
  • Stop print cooling fan at first layer.(ex: Regular fan speed at height :1mm)
  • Regular fan speed :20%
  • Max fan speed :40%

• UPDATE

  • 2019/03/30
  • Added X limit switch pusher.
  • Heat sink holder fixing improvement.
  • Print cooling fan air flow direction improvement.
  • Print stability improvement. (added small slit in first layer.)
  • Cable fixing slit improvement.
  • 2019/04/09
  • Add intake shroud for heat-sink cooler.
  • Split print cooling nozzle.
  • Cable fixing slit improvement.
  • Add "Non-Offset" version Main-body.

Please try and feedback anything!

Print Settings

Printer Brand:

Anycubic

Printer:

Rafts:

Doesn't Matter

Supports:

Resolution:

0.2mm

Infill:

Filament: PLA/ABS/PETG/nGen

Notes:

Category: 3D Printer Extruders