VW Audi (VAG) Chassis Grommet (1K0803583A )
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement chassis grommet printed in TPU
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 190
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Public Domain
An alternative solution to the extortionate price wanted for these grommets on the Internet marketplace.
If printed on a Prusa printer without an MMU. It is recommended to use the .gcode files attached, as it includes an integrated support within the model.
However, a .step file is also included without the support material, if preferred to print the grommet an alternative way.
The print must be printed in the following sequence:-
1). Load .gcode file attached (summary of settings below).
- Prusa FLEX default parameter used.
- 0.10mm (DETAIL) layer height.
- 50% infill.
- 0.4mm nozzle diameter.
- Creality CR Series TPU (Black) used.
- Apply glue to the Satin print sheet.
- Pause at layer height 5.0mm
- Masking tape is required for the next step.
- Craft Knife
2). Run the print, but when the printer pauses. Apply one even layer of masking tape to the obround supporting structure only, do not overlap. Using a craft knife, cut around the inner perimeter of the support and remove the inner section of masking tape, see photo attached. Finally, resume the print.
3). Remove print from the sheet.