1 / 3
Lens Hood for Canon EF-S 18–135mm f/3.5-5.6 IS USM (EW-73D) — zdjęcie 1
1 / 3

Lens Hood for Canon EF-S 18–135mm f/3.5-5.6 IS USM (EW-73D)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A traditional tulip-shaped lens hood for Canon EF-S 18–135mm. The hood mounts on bayonet and latches firmly on place.

Ocena
0 / 5
Polubienia
21
Pobrania
144
Wydruki
0
Wyświetlenia
621
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution

Canon EF-S 18-135mm f/3.5-5.6 IS STM is still a good lens, and acts as my primary lens. The official lens hood (EW-73B) is however overpriced, and new one is needed every now and then, as those have a tendecy to crack. A model for lens hood fitting my needs did not exist, so I made my own version mixing two designs. The end result is quite similar to the ‘official one’, but there is still room for improvement.

For me two features were must: snug lock mechanism and convinient tulip shape. Nothing is more annoying, than noticing vigneting caused by misaligned lens hood when editing photos. And while ‘boxy’ lens hood offer better protection, the tulip design is more portable. This design features these both: a tulip design with proper bayonet mount. 

Printing

Following configuration is recommended:

  • Filament: PETG, matte black. I used Prusament, but any other good quality one should work. I don't recommend PLA, as it is quite fraqile. (ABS/ASA might work also, untested.)
  • Configuration: 0.4mm nozzle, 0.2mm layer height, structural preset
  • Perimeters: 3
  • Minimum shell thickness, bottom: 1.5 mm
  • Infill: gyroid 15%

Scale

For a snug fit, printing in correct scale is important. Even on different colours of the same filament, fit can differ. I therefore higly recommend printing test prints for finding correct scale for your material. To save time and filament, I recommend cutting the top part off on slicer, and printing just the ring and first few millimeters of the hood itself. Start with 100% scaling, test on camera and adjust by one percentage point if necessary. I ended up having perfect fit with 99% scaling with matte black Prusament. (For white Prusament that would have been too tight.)

Surface finnish

This step is optional. The part should work fine without any extra effort for surface finnish. There are however couple of tricks to improve the end result. 

First trick is to use paint on fuzzy skin in slicer. That helps to create a texture, which disperses light more effectively avoiding reflections from the lens hood surface. Apply it on the lens hood surface leaving the bayonet ring as is. Otherwise the default settings will do. 

Even with matte filament, I found the print to be on somewhat shiny side. The last photo shows the part straigth from printer. Applying a layer of matte black spray paint can help to create perfect textured matte finnish. Be sure to cover the mounting ring with tape first. 

 

Tagi