Deburing Tool handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Extra Handle for Deburring tool that uses Filament to hold the tool in
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 179
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I could not get some of the deburring tools I found to work on the lower resolution printer I had. I made this all in one handle to use 1.75mm filament to hold in the tool. Just insert the the toolhead into the top and the insert two small pieces of filament into the two holes in the side of the tool and clip them off. There is a smaller hole on the other sides of the filament to allow you to push out the filament with a paperclip or pin. Model is tall and thin so there is supported model to help with bed adhesion because I had problems on an older printer.
Print in the tall orientation with hole facing up. I printed with a .6 nozzle and .32mm layer height with a brim on an old CR10S.
This worked for both deburring tools I had access to. Step file included if you need to modify to fit yours. Often these tools come with 8 or 10 extra blades that may be overkill for 3D Printing. Make a tool and have two on hand in case you misplace one or share a tool with a friend.
Example Deburring tool:
https://www.amazon.com/Romeda-Deburring-Rotary-Printing-Plastic/dp/B0DYS6MTGH/ref=sr_1_2