Lithophane Lamp with Lighted Backsplash
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a lithopane holder lamp. To generate a lithopane that fits go to…
- Ocena
- 5 / 5
- Polubienia
- 50
- Pobrania
- 182
- Wydruki
- 4
- Wyświetlenia
- 1433
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a lithopane holder lamp.
To generate a lithopane that fits go to https://lithophanemaker.com/Curved%20Lithophane.html and use the following settings:
- Height: 125
- Angle: 90
- Maximum Thickness: 3.2
- &Make sure you upload a 4:3 aspect ratio landscape photo
Settings not mentioned above shouldn't matter much for fitment.
Supplies Needed:
- 1x of every STL here, printed
- 1x printed lithopane that fits
For the light hardware, you can get creative. The following is just what I used:
- 1x 0.5in section of 1/8-IP thread 'nipple' (it's what's on the package)
- 1x Tapped 1/8-IP Hex Nut
- 1x E11 Socket /w a receiver for the 0.5in 1/8-IP nipple on the bottom (fairly standard lamp hardware)
- 1x 50-Watt Equivalent Bright White (3000K) T4 Mini Candelabra E11 Base Decorative LED Light Bulb
- 1x 8ft power cord
- 1x feed-through on/off switch
I've also included the STEP file in case anyone wants to further modify this lamp
Print Settings
Printer:
Seckit-Go
Rafts:
No
Supports:
No
Resolution:
0.25
Infill:
13% gyroid
Notes:
You may want to play with the extrusion thickness & layer height settings a bit to make sure gap fill isn't taking up an inordinate amount of time.
Category: Decor