1 / 4
Angled Twisty Puzzle Cube 1x3x4
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Easy Rubik's-like puzzle with two angled cuts to make it a little more interesting. Only requires one screw.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 198
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Puzzles & Brain-teasers
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (23)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (2)Powiązane
This puzzle is easy to solve since it is only a 1x3x4 cube. But the cuts at an angle give it an extra “twist” so there still is a bit of a challenge, plus it makes some interesting shapes.
The faces should snap into place, though they might need a bit of glue. I printed them with TPU and the rest of the cube in PLA. Print the “a” faces one color and the “b” faces a different color.
Some of the parts will need supports (those in build plate 1 in the 3mf file).
Assembly
| Find a wood screw 10 to 20mm long with a head no bigger than 8mm across. Drill out the hole in the center part p8 to a diameter just a bit smaller than your screw. The hole in part p5 can be slightly bigger. | |
| Fit together parts 1&4, 2&5, 3&6. Set them aside and fit together parts 7&10, 8&11, 9&12. Make sure part 2 with the hole through it is attached to p5, the rest can be interchanged with their opposites. |  |
| Fit the side pieces into the center pieces so that you have two halves. These halves will be held together by the screw. If you have one, small washer might help to keep the screw from working itself loose. A small amount of petroleum jelly may help everything to rotate a bit smoother. |  |
| Add the TUP faces. |  |