LilyGO T-Deck Tight Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A very tight tolerance case for the T-Deck built from scratch to stand upright.
- Ocena
- 0 / 5
- Polubienia
- 44
- Pobrania
- 209
- Wydruki
- 0
- Wyświetlenia
- 1876
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
The main design goal was for it to be able to stand upright on a table. Secondly i wanted it to be more symetric (the default T-Deck has the screen, keyboard and trackpad misaligned and is all sorts of wonky). I also disliked the transparent part around the trackpad with the goofy sticker underneath.
I included Fusion 360 design files, but beware they are a mess. I based some parts on the .step files provided by LilyGO and I had to mess with them quite a bit to get it all working and fitting.
I designed this for an original Samsung battery (GH82-28813A part number), BUT you can snip off the tabs that hold it at the ends and just stick on whatever battery you find that fits. The battery I used is 65x87x5 mm. If you're going to buy this battery beware that it comes with a flat flex cable and you'll have to cut it off somewhere and solder on some wires. Don't set your house on fire..
This is a tight case design. Depending on your printer's tolerances you might have to file down 0.1-0.2mm off some bits to get everything to fit.
BEWARE! This case requires you to remove the keyboard from the transparent keyboard holder completely. This means you need to fiddle with the flat flex cable that comes from the keyboard. Don't abuse it since it can crack if bent the wrong way. You can use a bit of isopropyl alcohol to loosen the two sided tape holding it on, it's not stuck on too much.
Extra bits:
2pcs. M3 screws
2pcs. M3 threaded inserts
1pcs. SMA connector with U.FL (IPEX) pigtail at least 80mm long
1pcs. Battery