Spacer Block for DonQuichotte KKB pressure clip / Erhöhungsblock für DonQuichotte KKB Klemmbügel Kabelhalter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Spacer for KKB pressure clips – improves grip on uneven surfaces or with thick cables.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 23
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
DEUTSCH
Dieser Erhöhungsblock passt für alle DonQuichotte KKB-Klemmbügel und ist dafür gedacht, wenn die Oberfläche stark uneben ist oder die Halter in Vertiefungen sitzen. Auch bei leicht zu dicken Kabeln kann es passieren, dass sich die Spitzen der Klemmbügel nach außen spreizen und das Kabel nicht mehr zuverlässig gehalten wird. Durch den leicht erhöhten Abstand zur Wand bleibt die Klemmwirkung an der Spitze erhalten – das Kabel wird wieder sicher gehalten und fällt nicht mehr heraus. Der Block lässt sich einfach drucken und wird direkt unter dem Klemmbügel montiert.
ENGLISH
This spacer block fits all DonQuichotte KKB clamps and is designed for cases where the mounting surface is very uneven or the clamp ends up in a recessed area. It’s also helpful when cables are slightly too thick – the clamp tips may spread outward and lose grip. With a slightly increased wall distance, the clamp tips maintain proper tension again, holding the cable securely so it won’t slip out. The block is easy to print and mounts directly beneath the clamp.
Category: Electronics