Medical enclosure/ medicine box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Medical enclosure to store medicines, inspired by videogames like COD/Splintercell. Open lower shelf for emergencymeds
- Ocena
- 4 / 5
- Polubienia
- 8
- Pobrania
- 28
- Wydruki
- 1
- Wyświetlenia
- 320
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Medical Tools
- Licencja
- Creative Commons — Attribution — Share Alike
Everyone has medicines at home like paracetamol and I'm not an exception. But I don't like to have them wandering around or in a drawer in the kitchen, I like them in their own enclosure. And what better look for an enclosure than a videogame- inspired one!
The design is based on the medic box in Splintercell and/or COD, with a special open shelf for emergency medication like Epipens or medicine boxes for day to day uses.
Mounting can easily be done by screwing one screw in the middle inside the enclosure or placing the cabinet over two screws in the top. If you feel the need for redundancy you can also use the two bottom mounting holes.
I wanted the smoothest swinging doors that I could easily make, so I melted a pop rivet in the door and cut it to length. In the bottom I melted a brass nut. In the top of the enclosure I loosely screwed a M3 screw.
You can use hexagon adjusting screws in the top if you don't like the look of screws. If I didn't go for the pop rivet, I would use an adjusting screw in the bottom.
***---***---***---***---***---***
Material list:
- 2x M3 hexagon adjusting screw (for door bottom hinge)
- 2x M3 x8mm (for door knob)
- 2x M3 x15mm (for door top hinge)
Parts2Print:
ENCLOSURE KIT:
- 1x Medicine_enclosure
- 1x Door_Left
- 1x Door_Right
- 1x Door_Stop
- 2x Door_knob
UPGRADES:
- 1x Medicmark
- 1x Medi ine_ampoule_and_medicine_tree
- 1x Medicine_tree
***---***---***---***---***---***
The design is printed on a Prusa MK4
I printed the enclosure with PLA and painted it. The design is completely printable without support. If I print it again, I would try to print the enclosure in an closed printer against warping. Its not that noticable, but happened by me.
I made two extra shelves to place inside the cabinet, as mentioned under upgrades.
Feel free to inprove the design or remix it. Design other trees or tools for inside or get inspired.
Happy healthy printing!
[M]