BPI-R4 120mm Fan Top Case Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Add a 120mm fan to the top of your BPI-R4. May work with other variations of the Banana Pi series but not sure.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 202
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
I was experiencing some high temps which likely caused my wan port to degrade due to me having to keep this in a closet. The model I have uploaded is slightly different than the one I printed, but it should all still fit. I increased the height and length of the fan mount because it was super flimsy when I put mine together, though it still works.
I printed this at 100% infill because it was rather thin but you could probably do less with my updated model. I had best luck by printing it on its side and using tree support for the middle section. It adds some time, but it's going to be hard to get support off the tiny overhangs.
All you need is a 120mm computer fan, fan screws, and a way to power the fan. I am powering it through a USB cable that is ran directly off the BPI-R4.
Enjoy!