Replacement part for side window handle of a HymerMobil (Mercedes 601 based)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement part for a missing side window handle
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 173
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
One of the handles to open, close and lock the side window of my father-in-law's mobile home was broken/ missing. The handle is equal on both sides, so I could “copy” the remaining one.
The “handle part” of the unit is only roughly similar as the original part - the important bottom part was measured and should fit. (Reference pint are the mounting holes).
I printed the part in PLA - as a prototype - for later I would suggest PETG or even ABS to survive the (possible) high temperatures in a car in summer…
PS: The photographs are made of a pre-version, there as one detail missing. The final model is shown in the rendering…
PPS:
The “+1mm wide version” is easier to install in the car.