Elegoo Wash and Cure 3.0 IPA pigment filter holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of https://www.printables.com/model/829951 for Elegoo Wash and Cure 3.0
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 170
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The filter screw is unchanged. For this system the Prusa filter holder bottom is not used – the wood mount screw holes or integrated bracket on the nut fills this purpose.
Both type H and type I filters are supported. These are made for small, above-ground pools, and can be bought in bulk inexpensively. Each filter can be used about 10 times, depending on how dirty you let your IPA get or if you pre-wash.
Print using a resin or filament resistant to long term IPA exposure.
If using the wood mount version, cut a piece of scrap wood to the width of the IPA tank, about 6 7/16" (163.5mm). It should be wide enough that it won't rotate within the tank, about 2 inches or more (50mm), and thick enough that your screws can grip it firmly (say, 3/4 to 1 inch; 20 - 25 mm). Sand or file lightly to prevent wood chips falling into your IPA.
The integrated hanging bracket version seems easier, but it's not as rigid and I prefer the wood mount.
For the Elegoo wash and cure 3.0, there is no “IPA filtering” option. Instead, the wash direction changes half way through the set time, which will defeat this type of immersion filtering. I usually clean the IPA when I'm draining the resin tank, sanding models, or doing other work near by, and it's easy to hear it slow and stop before reversing at the half way point, at which point you can turn it off, but you can also set an alarm if you think you'll forget.