1 / 3
Glyph - Phone Charging Dock
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
A wireless charging dock for phones. Tested with Samsung S10 and S22.
IMPORTANT: Check wireless phone charging capabilities and phone size before printing.
Center of charging coil is located ~7cm up from ledge where phone sits. Make sure that this is compatible with your device.
Charger module on Amazon: https://amzn.to/40x2IC3
How to assemble:
- Insert PCB into Base.
2. Thread wires through inside parts. Then connect these 2 parts.
3. Set inner parts on top of the Base.
4. Simply slide inner block inside the outer shell. The inner block should click into place once fully inserted.
