Additional plugs for Improved Fruit and Vegetable Washing Basin
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Plugs to balance/limit water consumption of the beast, needed those for my 125% version.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 58
- Wydruki
- 0
- Wyświetlenia
- 1408
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Set of additional plugs for the washing basin to cover the holes, when not needed.
I printed the basin at 125%, but my kitchen water tap just can not keep this monster running - water leaks out too fast before the berries even try to start to float. With the plugs I can fill it up to the top edge (if needed) and that quickly drain removing the center plug.
Obviously the cone one comes into the center, smaller are for the side holes (print as much as you need). The center one friction-fits, the side ones are snapped in.
Those are not 100% water tight, so not intended to totaly hold/store the water inside, but rather to limit the leakage. But you can always use superglue to fix this.
I designed those for the base version, but test prints were for my “big-guy” 125% version (plugs scaled to 125% also).