Train / Dept. 56 Model Street Lamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I resized the original design to be 1:48 scale so that 3.5" is equal to a 14 foot high street lamp. This size matches…
- Ocena
- 4,889 / 5
- Polubienia
- 188
- Pobrania
- 1101
- Wydruki
- 8
- Wyświetlenia
- 4463
- Oceny
- 9
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I resized the original design to be 1:48 scale so that 3.5" is equal to a 14 foot high street lamp. This size matches the Dept. 56 Snow Village houses. I increased the size of the hole through the middle so that wires could be fed through.
I've just added the same lamp scaled for HO train layouts which is 1:87 instead of the 1:48 of Dept. 56 Snow Village Houses. The lamp parts for HO scale have "HO" in the name. The HO scale lamp design has a hole down the middle that will accept the grain of wheat lamps referenced below.
I was able to print the glass section in clear PETG. This material is harder to print than PLA. If you have problems, white PLA also works for the glass section.
This is the link for the mini grain of wheat bulbs I used. https://www.amazon.com/gp/product/B01A6B5DYK
Print Settings
Printer:
HyperCube
Rafts:
No
Supports:
No
Resolution:
0.1mm
Infill:
70%
Filament:
HatchBox PLA
Grey
Notes:
I did use a brim to make sure the post stuck to the bed.
Category: DIY