Belted Z Ender 3 with wider screw heads
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Low height Ender 3 Belted Z mod parts edited with clearance for ~11mm diameter screw heads.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 154
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- GNU General Public License v3.0
When I got all the parts to assemble the mod, I discovered that the heads on the M5 x 8mm screws I had bought where too wide and would crack the parts when installed. Even after getting a few less wide screws, they still didn't fit. Thus I added more clearance for them.
Also, this was done to the parts having two Z axis motors mounted lower. Mostly because I was then able to use tilt adjust to get practically perfect first layers. Also the 300mm linear rails are not tall enough to reach the absolute top anyways since another mod and the silicone spacers have made the bed lower by about 30mm, and 330mm liner rails are a bit less common.
This should be printed just as the regular mod would have you do so. I would suggest PETG or PCTG at 20% - 40% adaptive cubic infill with 3 to 5 perimeters when using a common .4mm nozzle. I did 20% infill with 5 perimeters using PCTG with a .4mm nozzle.
