1 / 9
Skull Plant Pot or Pencil Holder HighDetail — zdjęcie 1
1 / 9

Skull Plant Pot or Pencil Holder HighDetail

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I added an open top vessel the a very nice and detailed human skull

Ocena
0 / 5
Polubienia
20
Pobrania
137
Wydruki
0
Wyświetlenia
631
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Share Alike

I added an open top vessel to a very nice and detailed human skull. I had to first unsharpen the detail of it a bit and  shrink it to meet TinkerCADs size restrictions. Modifications were made mostly in TinkerCAD and later the .stl file was scaled up equally to 165% in OrcaSlicer before final slice. the cross in the bottom to avoid acute leans of stored utensils.

Supports were Tree, Auto, TreeSlim stock settings 30deg

ESun PLA+, Ivory. I used a stock CrealityGenericPLA config with out any prior tuning. 

This is my first interaction with This filament and I would definitely use it again. 

I printed from drier where it was 11-12% humidity. 

0.20 base and subsequent layers also added a stock skirt and brim from the OTHER section of the  slicer

The supports were relatively easy yo remove. Crush lower thick area with  needle nosed pliers and pry model attachment with a 90deg metal pic, on the outer stuff. 

Same technique and much slower on the inner detail stuff. I may fill this area with a solid form to lower amount of supports to remove. You dig your way from build sheet up to the teeth and soft palette area.

The model allows you to remove SO MUCH SUPPORT MATERIAL from between the teeth. Be careful I could definitely see breaking off a tooth while doing this, or cracking the zygomatic arch from an overly tight grip. once your done call your dental hygienist and thank them. 

Thank You @3Demon for posting this amazingly detailed model.