1 / 2
Ubiquiti Wall Outlet Mount (Designed for AC-HD and AC-PRO, BUT should work with some other models)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Based on @d0b_58654's design, I modified it to better fit our household.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 61
- Wydruki
- 0
- Wyświetlenia
- 479
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
IMPORTANT: The mounting hole distance are slightly off with the official bracket, thought I didn't notice much difficulty during installation, so I can't be bother to correct those. But do let me know if it is necessary for your usage.
- Changed wall outlet holes to 4mm diameter and 3.281" from each other vertically. (I do realise the mix use of units..)
- Changed the mounting method with official bracket from M3 with nuts to predrill #8 square head screws.
- Save some material, but I added back some stiffening between top wall-outlet screw to top #8 screws to increase strength.
- Not even sure if that is necessary. Additional material reduction is very likely if you wish to do so.
- Added cooling vent, slimmer on top to reduce dust, but wider at bottom to increase convection.
- … ideally. I have not done proper test or calculation to verify the performance.
- FYI in my AP-HD, which could go above 50C at some spot when leaving flat on the table, is around 35C on the top vent, which is an improvement non the less.
Attached Solidworks 2025 part file for anyone who needs it.