Voron Stealthburner Ender 3 Hotend Printhead

This was designed in conjunction with a duender build with the challenge of not using any other parts than the parts that came with 2 ender 3s bought on fb marketplace

The printhead was made with the same overall height as an assembled revo voron do reduce the heat loss of the part cooling fan, keep the part cooling fan pointed at the molten plastic, enable to use of a BL touch and to allow for the easy swap for a revo voron when we grow bored of this challenge.

Note: The overall height of the printhead will depend on the “tolerances” of the ender 3 hotend components. Apparently, some manufacturers of the heatbreak make them longer or usually much shorter. The overall height was designed around 3 (supposedly) genuine creality hotends with the heatbreak bottomed out.

The picture in the thumbnail also shows an old prototype of the printhead and mount with the wrong heights (didn't notice when publishing). The files do not have that mistake.

The v2 has a known mistake of forgetting to remove the printed letter P from the P-BMS after editing it to say END3

(Ill fix it when I feel like it)

Note on the extruder and mounting plate:

Designed to with the “Voron stealthburner Clockwork2 nema17 with cable cover” in mind

https://www.printables.com/model/642252-voron-stealthburner-clockwork2-nema17-with-cable-c

Additionally, this is my adapter for mounting the stealthburner to an ender 3 carriage

https://www.printables.com/model/1345529-duender-stealthburner-mount