1 / 6
Astro A50 Gen4 (A00085) Headband to Headphone Mount - Right Side — zdjęcie 1
1 / 6

Astro A50 Gen4 (A00085) Headband to Headphone Mount - Right Side

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement right-side Headband to Headphone mount for the Astro A50 Gen4 (A00085) wireless gaming headset.

Ocena
0 / 5
Polubienia
1
Pobrania
97
Wydruki
0
Wyświetlenia
423
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Audio
Licencja
Creative Commons — Attribution

This is a replacement part for the Astro A50 Gen4 (A00085) for the right side mount that connects the headband to the headphone slider arm.  This model is slightly different from the original mount.  It is slightly thicker at the bottom then the original (there is a photo showing both from a side profile on the headset).  However, it does provide more meat near the screw holes where the original mount broke, which should reduce it breaking again in the future.

 

Please pay close attention to the way the wires are run inside the original part, they cross inside the mount and this mount was made to replicate that via the internal wire channels.

 

Printing

The printed mount in the photos were done with the following:

  • Filament: Sunlu ABS Black
  • Layer Height 0.2 mm
  • Infill percentage: 40%
  • Infill type: Gyroid
  • Wall count: 4
  • Solid top/bottom layers: 5
  • Supports: Yes

I recommend printing it in the standing orientation that the model comes in for the best result.  I tried printing it with the face down on the plate, but this resulted in horrible looking side faces.  The one in the photos was standing up with supports on and Support on build plate only turned off in SuperSlicer.  This will cause supports on the part, but if your printer is tuned properly, this should come cleanly off using ABS with SuperSlicer.

 

BOM

You will be able to use the original screws and washers.  However, in the event you misplaced one or more of them, the following should work as replacements:

 

ItemQty
M3x81
M2.5x42

 

Tagi