ZK-1002T case (+ cooling fan)

This designe is based on ZK-1002T a single board audio amplifier.

I needed a small box to protect the electric compoenets from most of the "dangerus" stuff (expecially liquids).

As I'm planning to use it on the highest range of it capables, I added a 40x40x10 fan to keep it cool (I know it's not the best position for this type of fans, but it's what I got for free).

You'll need some screws:

• 4 x m2 4mm (to secure the board on the box)
• 2 x m3 12mm ( to secure the fan on the box)
• 4 x m3 6mm (to secure the hood to the box)

Hood is composed by 2 pieces.

• the main body
• a thin plate

Just print one of each and glue the thin plate on the inside of the main body with superglue.

If you decide to use a fan, you have to solder the wires from the fan on the pins directly on exposed pins of dc plug. I suggest to print the feet of the box to free the inlet on the bottom (just 4 cubes 10x10x7), I've use TPU but PLA should be fine too.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

Supports:

Resolution:

Infill:

Filament: - PLA

Category: Music