Rear Dashcam Trim Mount for Removable Windows
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Minimal Flag Style Mount for Rear Dashcams in vehicles that have removable windows. Tested on 2021 Toyota Tundra.
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 215
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
Print Settings:
Material: PETG - ASA or ABS recommended.
Supports: Yes - Build Plate Only
Infill: 100% Concentric
This is a minimal flag style mount for rear dashcams in vehicles that have movable windows. Such as Toyota trucks and full size SUVs.
Will need 3M VHB or similar double sided tape for mounting to the flag style mount.
Tested on 2021 Toyota Tundra.
I am not responsible for damages from use of this model.
This requires temporarily pulling off a small portion of the top weatherstrip rubber. Please read all instructions below before attempting.
Installation Instructions:
DO NOT PULL THE SEAL ALL THE WAY OFF.
Only pull a small portion of the seal off the top of the cab window frame.
The weather strip may have a large amount of colored grease inside and if not careful, it might get on upholstery or headliner!
Roll down rear window.
With the window down, climb onto the rear seats and gently pull down on the top-center of the rear weather strip gasket. Only pull a small portion of the weather strip. Enough to get the skinny side of the printed model inside the gasket.
Holding the model by the thicker flag mount side, install this clip inside the weather strip's cab-side gasket. The contours of the model should seat neatly into the gasket.
Gently re-install the weatherstrip to the cab.
Test the window opening and closing BEFORE and AFTER installing dashcam for clearance issues.
I am not responsible for damages from use of this model.