DecorDisk 5L Model 1007033 LED Path/Border Light - flat mounting standoff for paths to prevent water ingress.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Brilliant lights, but not waterproof on the bottom so a rain puddle will cause rust and shorting. Simple standoff mount.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 48
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
These nice LED path/border solar lights are pretty water resistant on the top, and come with the black plastic widgets to create a mounting spike for pushing them into soil.
We initially just put them on the path, not realising that the bottom isn't at all waterproof so the first time it rained, one of them stopped working. I looked inside, and loads of water in there! Cleaned and dried, and it's working again. So they need a standoff to keep them out of puddles if you want to mount them on an exterior flat surface exposed to rain.
This design creates a 10mm standoff which should be enough to keep them from sucking up a puddle :o) If you need more standoff, or want less standoff for some reason, let me know and I'll add more STLs.
I printed in PLA+ so anything should do really. I used 0.4mm nozzle, 0.2mm layers, no special settings, no adhesion, no support, minimal infill (my standard in Cura is 15%). Designed to be a snug press-fit into the existing holes in the base of the unit. If yours prints a little too tight or loose you'll probably get away with scaling the X/Y down or up by 1-2% but mine fit just fine.
Please Like this model if you find it useful.
If you REALLY like it, https://www.buymeacoffee.com/gigabeast :o)