Cordmate II - Flat Elbow (Improved fit)

This is a Cordmate II flat elbow to connect chennels at a flat 90 degree angle. The ones provide in the kit are incredibly loose, dangle, and fall. I have channels on my garage ceiling for my LED lights and it looked janky with dangling elbows.

I tightened up the fit on these, and extend the catches so it fits tightly with only 1 channel (the other one going to the light).

Legrand Cordmate II Kit

BTW: I have Barrina 8 ft T8 LEDs (72W, 9000LM, 5000K) - Out of the box they're amazing! I daisy chained 2 sets of 5 of them (separate outlets for each set) and they are (were) extremely bright. I bought them 3 years ago, and I'm not starting to see LEDs die out on every tube and there are 2 tubes completely dead. They're not easily repairable, as the LEDs are on printed circuit board ribbons without visible solder to the LEDs… and the transformer assy is likely bad for the strands that are completely out. They're a good price out of the box, but consider you'll have to replace some or all every couple years. 

Printer Settings

• Material Type: PLA - Not limited to

• Layer Height: 0.2 mm

• Top/Bottom Layers: 5

• Wall Thickness: 1.0 mm

• Supports: No

• Infill: 15%, Grid (not required)

• Ironing: Yes (not required)