THE M&M VAULT: The Mass-Storage Solution for M&M's

My original creation, imported from Thingiverse

Sometimes the little M&M packets aren't enough for you. The M&M's fall out, and there's only so many. To solve this previously unavoidable problem, I have designed this M&M vault that can hold up to 56 M&M's!

There are four drawers that pull out from the main cask, each supporting 14 M&M's.

Since this is a simple print, any printer should be able to print it. The M&M's were measured carefully and given a generous clearance (The M&M's weren't put to waste, they were eaten afterwards)

Print Settings

• Rafts:

No

• Supports:

No

• Resolution:

0.16 mm to 0.2 mm (it actually doesn't matter)

• Infill:

Any (though I wouldn't set it too heigh, or it'll take too long)

• Filament material:

Any (but I used PLA) (TPU isn't recommended for obvious reasons)

This should be a two color print (but can be printed in one color). I printed in black and white, which were the only colors I had.

Notes:

You shouldn't adjust the horizontal layer expansion on the Holder Drawer v11, but you could (if you print it out and find that the slides don't go in) on the Drawer Holder v6.

You shouldn't do it on the drawers because the walls were designed for a 0.4mm nozzle, and any negative horizontal expansion could be bad for the print quality.

Good luck printing!