1 / 6
Stapeldorn modular für Paterson Entwicklungsspiralen;  modular stacking mandrel for Paterson development reels — zdjęcie 1
1 / 6

Stapeldorn modular für Paterson Entwicklungsspiralen; modular stacking mandrel for Paterson development reels

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Stapeldorn modular für Paterson Entwicklungsspiralen; modular stacking mandrel for Paterson development reels

Ocena
0 / 5
Polubienia
0
Pobrania
6
Wydruki
0
Wyświetlenia
91
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

Modularer Stapeldorn für Paterson Entwicklungsspiralen damit diese nicht im Schrank herumfliegen. 
Der Stapeldorn kann mit verschieden langen Segmenten beliebig lange oder kurz zusammengestellt werden. 
Bestehend aus einem Bodenteil, einer Abschlußkappe und fünf verschieden langen Rohren, für jeweils eine, zwei, drei, vier oder fünf Entwicklungsspiralen.
Die Spiralen haben genug Spiel auf der Spindel damit sie leicht abzunehmen sind.
Tips zum Druck:
alles mit Layerhöhe 0,2 und ohne Stützmaterial gedruckt.
Die Kappe mit dem Gewinde nach oben legen und eventuell ein paar Millimeter Rand / Brim geben.
Die Rohre senkrecht mit dem Innengewinde nach unten und dem Aussengewinde nach oben hinstellen, etwa 5 Millimeter Rand / Brim geben damit es nicht umfällt.
Könnte auch für andere Marken wie Paterson passen, aber es standen nur Paterson Spiralen zum Ausprobieren zur Verfügung.
………………..
Modular stacking mandrel for Paterson developing reels to prevent them from flying around in the cabinet.

The stacking mandrel can be assembled using segments of different lengths, making it as long or short as desired.

Consists of a base section, an end cap, and five tubes of different lengths, each for one, two, three, four, or five developing reels.

The coils have enough play on the spindle to make them easy to remove.

Printing tips:
All printed with a layer height of 0.2 and without support material.

Place the cap with the thread facing up and possibly add a few millimeters of edge/brim.

Place the tubes vertically with the internal thread facing down and the external thread facing up, adding about 5 millimeters of edge/brim to prevent them from falling over.

It might also fit other brands like Paterson, but only Paterson reels were available for testing.

Tagi