Batavus sparta ebike round display holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Additional holder for damaged Batavus sparta ebike round display
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 177
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Public Domain
WARNING:
This is not original part of the manufacturer. You might lose your warranty. Print and use it at your own risk.
This part is intended to hold display with broken handles to its base. After installing it, you can't remove display easily.
Printing tips:
Model is partially pre-supported, designed for printing with 0.6mm or smaller nozzle. It will only work with soft/medium TPU filaments, as you need to insert display and base inside. Correct print orientation is wider part facing down. You might want to add supports in the hole for side display button.
I printed it on CR-M4 with 0.6mm volcano nozzle, 0.2mm layer height, 70% infill and 80% fan speed. It should print well if you have calibrated profile for TPU.
Assembly:
First, clear supports from the bottom and side of the print and cut off sagging bridges. Then slide display in that you can press the button through the hole on the side of the part. Next, put in the base and connect it with the display. Then slide 2 zipties (max. 4mm wide) into the part and tighten these. The mount does not prevent display from rotating on the base, check in which position it works.